Theon’s 419-HP Porsche 911 Restomod Weighs 2,535 Pounds
- Robert Jones
- 670 views
Theon’s 964-based 911 pairs a 419-hp flat-six and carbon-fiber panels with tuned suspension, a five-speed manual and a 2,535-pound curb weight.

Theon Design’s latest 911 puts its priorities in a striking order: a naturally aspirated 419-hp engine, a five-speed manual and a claimed weight of just 2,535 pounds. The Oxfordshire-built commission uses a 964-generation Porsche as its starting point, then combines extensive weight reduction with updated suspension and a cabin trimmed in Beechnut leather. The project also marks the company’s 10th anniversary.

Those figures give the car a very different character from a typical modern performance coupe. Its 4.0-liter flat-six sends 322 lb-ft of torque to the rear wheels through a G50 five-speed transmission. The engine has selectable maps, including a “town mode” intended to soften its response for everyday use. That flexibility matters in a car designed around a high-output, naturally aspirated engine: the driver can choose a calmer setting for slower streets, while retaining the option of a more assertive response elsewhere.
The low weight is central to the brief. Carbon-fiber body panels save roughly 660 pounds compared with the original car, according to Theon. The company also says the completed 911 weighs 2,535 pounds. That makes the build’s appeal about more than engine output: reducing mass can shape how quickly a car responds to steering, braking and changes in direction, while also easing the load on its tires and suspension. The published figures describe the finished commission; they don’t establish a direct performance comparison with another 911.
A 964 with a lighter touch
Theon says it strips each donor car to its bare shell before rebuilding it. The approach preserves the 964’s proportions and basic character while revising its mechanical systems. That’s a different emphasis from simply chasing the largest possible power figure or making an older 911 look and feel entirely new. Here, the carbon panels and revised components serve a build intended to retain the familiar outline while changing how the car responds on the road.
The exterior wears Oak Green Neo Metallic, a modern finish chosen as a reference to Porsche’s classic Oak Green. Champagne-colored Porsche lettering and 17-inch wheels complete the look. Underneath, the car uses brakes from the Porsche 993 RS. The relatively modest wheel diameter also leaves room for tires with taller sidewalls, a choice that connects the appearance to the car’s road-focused setup.

Suspension set up for rough roads
The suspension is tuned specifically for British roads, Theon says. It pairs TracTive semi-active dampers with custom spring rates and revised steering. Michelin Pilot Sport tires with relatively tall sidewalls are fitted to the 17-inch wheels, adding some compliance over rough pavement. The stated goal is to combine sharp turn-in and controlled body movement with enough ride comfort for longer drives.
That balance is a useful measure of a road-focused restomod. A setup that feels precise on smooth tarmac can become tiring when the surface gets uneven, while a softer tune can give up some immediacy in corners. Theon’s combination of adjustable damping, tailored springs and taller tire sidewalls is meant to address both demands. The available information describes the design intent, but doesn’t provide independent road-test impressions or comparative ride measurements.
Some of the changes are less visible. The original heating and air-conditioning system gives way to a new electric unit, and a lightweight wiring harness saves about 55 pounds, according to Theon. Even the window switches have been redesigned and machined from aluminum. Together, those details show how the weight target extends beyond the exterior panels, while the updated climate system addresses the everyday comfort expected of a car that’s meant to cover longer trips.

Part of a wider 911 program
The anniversary car sits alongside Theon’s more extreme Theon R, which is targeting more than 500 hp and a curb weight below 2,205 pounds (1,000 kilograms). The first customer R is under construction. Those targets suggest a separate direction within the range: the current commission couples substantial power with a relatively road-friendly specification, while the R aims to push both output and weight reduction further. The R’s figures remain targets, rather than completed-car specifications.
Theon has also launched an online configurator for its Coupe, Targa and R models, and established a US presence through Humble House, which provides local concierge support for American customers. Coupes start at $575,000 (£435,000), before the donor car, shipping and taxes. That starting price makes the build a bespoke purchase, with the final outlay dependent on costs beyond the stated base figure.
The clearest takeaway is the balance Theon is pursuing: classic 964 proportions, a manual gearbox and a naturally aspirated engine, supported by modern suspension and comfort equipment. The 2,535-pound claim and 660-pound panel saving explain the engineering focus, while the road-specific chassis details point to the intended use. The next useful benchmark will be the completed customer Theon R, which will show how far the company can push the same lightweight approach.